To begin we will have to unhook the back cover, for this we will use a suction cup and a fine tool, once we raise the casing we will be able to introduce some thicker tool. We must be careful with the flexes that are glued to the housing.

We disconnect and remove the two interconnection flexes.

We disconnected the flex from the battery, and removed the four Phillips screws (PH # 00) that hold it.

We apply heat to the screen, and with a fine tool we will raise the screen a little, to continue detaching it with plastic spikes so as not to damage the paint on the screen. Once all the edges have been peeled off, we remove the Phillips screw (PH # 00) that holds the shield that covers the connector of the screen, and we can remove the screen.

We remove the nineteen Phillips screws (PH # 00) that hold the frame of the tablet and unhook it from the chassis.

We remove the front flash.

We disconnect and remove the cameras.

We disconnect the speakers and the coaxial cable, and unhook the right speaker.

Remove the six Phillips screws (PH # 00), remove the blidaje that is on top of the base plate, and we can lift the base plate that we are going to replace.