Guide with all the necessary steps so that you can change the touch screen of the Primux Tablet UP mini yourself.
We will start by removing the microSD card so that it does not bother when removing the case. To do this, we will press it lightly so that it is automatically ejected.
On the right side of the tablet, we will find two Phillips screws (PH # 00) that hold the case to the chassis. We will remove them and begin to disengage the chassis housing.
Introducing an opening tool between the frame and the housing, we will release the notches that hold it.
Before removing the casing, we will have to take off the speaker that is stuck to it.
To remove the touch screen, first remove the adhesive covering the connector on the motherboard. We lift the tab of the connector and disconnect the flex.
With the screen disconnected, we will heat it to soften the glue and thus facilitate the extraction.
We will introduce the Hotglass in the microwave for approximately two minutes. If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.
It is advisable to interrupt every 45 seconds and knead the gel inside with your hands to distribute the heat.