We started by heating the screen at about 60ºC for about a minute, to soften the adhesive. With the hot screen, we introduce a flat tool between it and the frame. Sliding it around the contour we will take it off.

We will take care in the left part and in the inferior part, since we can damage some flex.

Remove the shields covering the connectors, levering and releasing the notches that hold it. Then we disconnected the screen to be able to move it away.

We remove the shielding that covers the processor to be able to remove the dissipator. Then we removed the four Torx T5 screws that hold the heatsink in the processor part and the remaining six Torx T4 screws.

We remove the two Torx T4 screws that hold the reader to the chassis and remove the shield covering the connector. It only remains to disconnect it from the motherboard.