First, we apply heat to the back to soften the adhesive and to be able to peel it off.

We introduce a metal tool to make our way and then we introduce a plastic spike-type tool so as not to damage the casing and we separate it around its entire contour until it is completely detached.

With a Phillips screwdriver (PH # 00) we extract the eleven screws indicated to separate the housing from the terminal with a thin plastic tool.

With a fine opening tool we disconnect the battery to work more safely.

We release all the camera connections one by one and extract the module that is on the motherboard.

With a fine tool we loosen the connection of the front camera and extract it.

We extract the headset from its housing with a fine tool lifting it from its lower part.

We extract all the connections that are on the motherboard, interconnection flex, fixing screw, sim tray ... to be able to extract the plate from its housing.

With a fine tool we lift the motherboard and extract it from its housing.

With a fine tool we detach the flex from the housing and with the help of antistatic tweezers we extract the sensor from its housing.

We extract the shields that hold the side buttons to be able to extract the fingerprint reader and then we remove it with the help of antistatic tweezers, then we take off the flex and the side button with a fine tool and remove it.

With a Phillips screwdriver (PH # 00), we extract the seven screws from the speaker module, and with a thin plastic tool we extract it from its housing.

With a thin tool we release the interconnection flex and now extract it with the help of antistatic tweezers, extract the battery adhesive little by little until it is released and with the help of a thin tool we extract it from its housing

With a fine tool we disconnect the coaxial cable and remove it to be able to extract the auxiliary plate with the help of a fine plastic tool.

With a fine tool we extract the vibrator from its housing, leaving the screen free of components.