To begin, we must apply heat to the back cover to soften the adhesive, and with the help of a suction cup and a very fine tool we will open a small hole through which we will insert a plastic spike, and thus we will avoid scratching the case.

We extract the seventeen Phillips screws (PH # 00) that hold the case, we will also remove the card tray, and with the help of a flat tool we will unhook all the sides of the case.

We disconnect the battery and the fingerprint reader.

We disconnect and remove the front camera.

We disconnected all the rear cameras to avoid damaging them when handling the motherboard.

We disconnect the interconnection flex, the coaxial cable, and peel off the adhesive that joins the base plate and the earphone, and with the help of a flat-tipped tool we will carefully lift the base plate.

To finish, with the help of flat tweezers we will detach the area of the headset contacts, and with a fine tool we will detach the body of the headset that we have to change.