We apply heat to the housing to soften the adhesive, and with the help of a thin metal tool we introduce it between the back cover and the phone, and now we will introduce a plastic pick with which it will be less likely to scratch the terminal and take it off.

Unscrew the eleven Phillips screws (PH # 00) that hold the plastic protector, remove it to access the battery connector.

With the help of a thin plastic tool, we release the battery connector.

With the help of a thin tool, we release the protective sticker from the camera, then release the camera connector with a thin plastic tool, and remove it from its housing.

With a fine plastic tool, we release the three connectors from the cameras and proceed to remove them from their housing.

We remove the seven Phillips screws (PH # 00) that hold the speaker module, once the screws are removed, with a thin plastic tool we lift it by prying

To remove the auxiliary plate, we will use a fine plastic tool, with it we will release the three connectors that we have and the coaxial cable once loose, we lift the flex by the base making a lever until it is removed from its housing.

With the help of a thin metal tool, we introduce it between the phone's chassis and the fingerprint reader, and thus we take off the component by doing a little lever.

With the help of a thin plastic tool, we release the flexes that are connected to the motherboard, once removed, we will release the necessary components for the extraction, as well as the sim tray and the coaxial cable, with the help of a thin tool we proceed to pry the base plate to remove it from its housing.

With a thin metal tool, we introduce it between the handset and the phone's chassis, with a slight lever we will extract it from its housing.

With a thin tool we lift the adhesive to pull it with antistatic tweezers to remove the adhesive from under the battery, after removing the adhesive introduce a thin plastic tool and gently pry until the battery is completely removed.

With a thin metal tool, we extract the protective plastic from the pushbuttons by prying as in the image, then we take off the flex of the pushbuttons and the pushbuttons with a fine metal tool and remove them.

Helping us with a thin metal tool, we take off the vibrator at its bottom as if it were the flex, and with the help of a clamping tool we remove it from its housing.