To start we must take off all the edges of the back cover.

Remove the twelve Phillips screws (PH # 00) and with the help of a flat tool unhook the intermediate housing.

We disconnect the battery to work with greater security, and remove the lens from the cameras to work with greater comfort.

We disconnect and remove the rear cameras.

We disconnect all the components that are connected on the motherboard

Remove the female flat screw that holds the motherboard and with the help of a flat tool we will lift the plate.

We remove the rubber covers that are in the hollow of the push-buttons, take off the area of the contacts, and with the help of a thin tool we unhook the push-buttons by the tabs of the shield to which the flex is attached.

We remove the proximity sensor.

We take off the headset with the help of a fine tool.

Remove the Phillips screw (PH # 00) that holds the lift motor and remove the engine.

We remove the front camera.

We remove the eight Phillips screws (PH # 00) that hold the speaker, and with the help of a flat tool we will unhook it.

We remove the tray from the cards.

We take off the adhesive that covers the connector and we can disconnect and remove it.

We disconnect and remove the coaxial cables, disconnect all the components that are connected to the auxiliary plate, and with the help of a flat tool we can already unhook it.

We take off the fingerprint reader.

We take off and unhook the vibrator.

We carefully take off the battery.

We take off the interconnection flex, and the plate with antenna connections from the full screen that we have to replace.