We unhook and remove the back cover.

Unscrew the Phillips screws (PH # 00) that hold the metal housing of the battery and the upper housing. We remove both.

We disconnect the flex from the battery. We took it off and removed it. We can help ourselves by wetting the plastic tool in alcohol a little to help take it off better.

We apply heat to the screen, for two minutes at eighty degrees.

We introduce a metal spike between the screen and the central housing, we exchange it for a plastic spike to avoid scratching the housing. We perform the entire contour by peeling off the adhesive that holds the screen until it peels off

Unscrew the Phillips screws (PH # 00) that hold the lower case and remove it.

We disconnect the flex from the screen of the motherboard and the auxiliary board.

We take off the flex from the screen of the central housing and remove it completely.