We will apply heat to soften the adhesive that holds the case, we will introduce a thin metal tool to open some gap through which we will put a plastic tool, so as not to scratch the case, and we will take off all the edges.

We remove the remains of the adhesive that cover the screws, we extract the card tray, and we can remove the fifteen Phillips screws (PH # 00) that hold the intermediate housing, we disconnect the flex from the fingerprint reader, and we can unhook the intermediate casing.

We remove the adhesives that hold the upper case and the Phillips screw (PH # 00) and we can lift it.

We disconnect the battery to work with greater safety.

With the help of a flat tool we unhook the module where the loudspeaker and the vibrator are located, and with flat tweezers we will detach the vibrator from the module that we are going to replace.