We will start by heating the back cover to soften the adhesive that holds it. In the fourth image, we show you the areas to avoid when entering the tool.

With the hot lid, we introduce a flat tool between it and the frame to detach it. We will avoid the areas of the antennas as much as possible.

We will also take off the rear fingerprint reader before separating the lid.

Remove the twenty Phillips screws (PH # 00) and then undo the middle housing and speaker module.

We raise the armor at the top to disconnect the battery and then remove it.

In this step we remove the fingerprint reader and disconnect the rest of the components from the motherboard. We will also take off the 5MP rear camera of the chassis.

Remove the three Phillips screws (PH # 00) that hold the motherboard and also remove the SIM / SD tray. Now we will lift the plate by the top to disconnect the interconnection flex.

We remove the adhesive that sticks the chassis to the screen and also take off the front camera.

We heat the screen at about 60ºC for about a minute. With the hot screen, we will slide a flat tool between it and the frame to remove the adhesive.