We will start by heating the back cover to soften the adhesive that holds it. In the fourth image, we show you the areas to avoid when entering the tool.

With the hot lid, we introduce a flat tool between it and the frame to detach it. We will avoid the areas of the antennas as much as possible.

We will also take off the rear fingerprint reader before separating the lid.

Remove the twenty Phillips screws (PH # 00) and then undo the middle housing and speaker module.

We raise the armor at the top to disconnect the battery and then remove it.

To finish, we disconnected the camera from the motherboard, took off the flex screen and uncapped the camera.