To start we will remove the card tray.

We extract the two Torx screws (T3) that hold the casing at the bottom, and with the help of a fine tool we will unhook it from all the edges, but before removing it we will have to take off the fingerprint reader, for this we will only have to exert a slight pressure on the reader.

We remove the seven Phillips screws (PH # 00) that hold the intermediate housing, and before unhooking it we will have to detach the flex from the NFC antenna, and with the help of a fine tool we will remove it.

We disconnect the fingerprint reader to work with greater comfort.

We disconnect the battery to work with greater security.

We extract the five Phillips screws (PH # 00) that hold the speaker to the chassis, and with the help of a flat tool we will unhook it.

We disconnect the bridge flex, the coaxial cable, and take off the vibrator.

We remove the Phillips screw (PH # 00) that holds the auxiliary plate to the chassis, and finally we will have to desolder the vibrator from the damaged auxiliary plate that we have to change.