To start we will remove the card tray.

We extract the two Torx screws (T3) that hold the casing at the bottom, and with the help of a fine tool we will unhook it from all the edges, but before removing it we will have to take off the fingerprint reader, for this we will only have to exert a slight pressure on the reader.

We remove the seven Phillips screws (PH # 00) that hold the intermediate housing, and before unhooking it we will have to detach the flex from the NFC antenna, and with the help of a fine tool we will remove it.

We disconnect the fingerprint reader to work with greater comfort.

We disconnect the battery to work with greater security.

We disconnect the bridge flex, the coaxial cable, and take off the vibrator, we will remove the Phillips screw (PH # 00) that holds the auxiliary plate, and with the help of a flat tool we will take off the auxiliary plate with the vibrator.

We take off and disconnect all the components of the motherboard.

We extract the two Phillips screws (PH # 00) that hold the motherboard, and with the help of a flat tool we will carefully lift it, since two connectors of the bridge flex are connected at the back.

With the help of tweezers we will unhook the coaxial cable.

We peel off the sticker on top of the battery, and we will peel off the NFC antenna and the battery.

It would not be necessary to detach the adhesive and the NFC antenna from the battery, you could detach the battery directly with the antenna and the adhesive on top, we have done it this way for convenience when making the other guides.

To finish we will only have to take off the flex of the side buttons and the bridge flex of the screen that we have to replace.