We apply heat with a thermal mat on the screen, with a metal tool we will open a small gap and introduce a plastic spike, with which we will take off all the edges until we can take them off all their contour.

Once the screen is separated, we will remove the Phillips screw (PH # 00) that holds the shield, we will remove it with an antistatic clamp and release the connector with the help of a plastic tool.

Once the screen is separated, we remove the tray, and remove the eleven Phillips screws (PH # 00) that hold the intermediate housing.

Once the intermediate housing of the terminal is separated, we disconnect the battery with the help of a plastic tool.

We remove the three Torx screws (T5) to remove the frame, then with a thin metal tool we extract the adhesive that surrounds the button, and from its base with the same tool we take it off until it can be removed from its housing.