We apply heat with a thermal mat on the screen, with a metal tool we will open a small gap and introduce a plastic spike, with which we will take off all the edges until we can take them off all their contour.

Once the screen is separated, we will remove the Phillips screw (PH # 00) that holds the shield, we will remove it with an antistatic clamp and release the connector with the help of a plastic tool.

Once the screen is separated, we remove the tray, and remove the eleven Phillips screws (PH # 00) that hold the intermediate housing.

Once the intermediate housing of the terminal is separated, we disconnect the battery with the help of a plastic tool.

With a thin plastic tool, we disconnect the front camera, and proceed to remove it from its housing, we extract the three Phillips-type screws (PH # 00) that hold the base plate, with a thin plastic tool, we pry on the base plate, to lift it from its housing.

With a thin metal tool, we release the plastic cover that covers the base plate and the adhesive, and remove the plastic cover

Once the plastic cover is released, we release the coaxial cable, and we will have the plate completely released.

With a thin plastic tool, we release the camera connector and remove it from its housing with tweezers.