To start we apply heat to the screen to soften the adhesive, and with the help of one or more plastic spikes we will peel off all the edges of the screen.

Once the screen is detached we must remove the Phillips screw (PH # 00) that holds the shield that covers the screen connector, and we can disconnect it.

Remove the twelve Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a thin tool we will lift the housing.

We disconnect the battery to work with greater security.

We disconnect the flex bridge and the microphone flex.

Remove the three Phillips screws (PH # 00) that hold the auxiliary plate, take off the vibrator that is welded to the plate, and with the help of a flat tool we will lift the auxiliary plate, and when we turn it around we must disconnect the coaxial cable that It is connected to the back of the board.

To finish we just need to desolder the broken vibrator that we need to change.