To start we apply heat to the screen to soften the adhesive, and with the help of one or more plastic spikes we will peel off all the edges of the screen.

Once the screen is detached we must remove the Phillips screw (PH # 00) that holds the shield that covers the screen connector, and we can disconnect it.

Remove the twelve Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a thin tool we will lift the housing.

We disconnect the battery to work with greater security.

We disconnect the flex bridge from the motherboard, and the flex from the side push buttons, and do not forget to remove the card tray.

We remove the three Phillips screws (PH # 00) that hold the plate, and with the help of a flat tool we will lift it, and we will have to disconnect the coaxial cable that is connected by the back of the motherboard.

Finally, we disconnect the flex from the angular rear camera, disconnect and take off the front camera and now we can unhook the cover, and we will only have to disconnect the rear camera that we are going to replace.