We remove the SIM tray from the mobile.

Remove the Torx screws (T4) that are on each side and remove the metal sheets.

We apply heat to the screen, for 2 minutes at 80 degrees.

We introduce a metal pick between the screen and the mobile. We exchanged it for a plastic spike so as not to scratch the screen or the frame. We do all the contour taking off the screen.

We remove the Phillips screw (PH # 00) that holds the metal sheet that covers the flex of the screen. We disconnected the screen and removed it.

Unscrew the Torx screws (T4) and the Phillips screws (PH # 00) that hold the center housing and remove it by prying it off.

We disconnect and remove the front camera. We disconnected the flex of the battery and the flex of the rear camera with front flash.

Unscrew the Phillips screw (PH # 00) that holds the motherboard and unlock it.

We disconnected the flex from the antenna and removed the top antenna.

We disconnect, take off and remove the proximity sensor.