With an opening tool we remove the back shell by prying.

With the same opening tool we remove the battery.

Unscrew the Phillips screws (PH # 00) of the intermediate housing and remove it by prying it off.

We desoldamos the vibrator very carefully and we take them off the base plate.

We disconnect the flex from the front camera to remove it.

We disconnect the flex from the rear camera and remove it.

We disconnect the flex from the side buttons.

We disconnect the flex from the screen and the digitizer from the motherboard.

Unscrew the Phillips screw (PH # 00) from the base plate and remove it.

We take off the headset carefully.

We heat the screen to 60 degrees for one minute, and carefully introduce the metal pick. Once introduced, we exchange it with a plastic spike, so as not to leave marks on the digitizer.

Little by little, we are taking off the screen until it is completely detached.