We will start by removing the screen, for this we will warm it to about 60ºC during a minute approximately.

With the hot screen, we will introduce a tine or another flat opening tool and move it around the contour to remove the adhesive.

To remove the screen, we will disconnect it from the bottom.

Remove the ten Phillips screws (PH # 00) that hold the shield, disconnect the battery and remove it.

We remove the SIM / SD tray and then disconnect the coaxial cables and disengage the side antenna.

We disconnect the flex from the charging connector and the push buttons and vibrator. We remove the casing / antenna that is on the side of the plate and then we disengage it.

All that remains is to detach and disengage the connector from the chassis.