We apply heat to the back casing, and with the help of a fine tool we will just raise the casing to introduce one or more plastic tines, and thus we will not scratch the casing.

Disconnect the flex interconnect fingerprint reader.

We extract the fifteen Phillips screws (PH # 000) that hold the intermediate housing, and with the help of a flat tool we will disengage it.

We remove the Phillips screw (PH # 000) and the shields around the rear camera, and we can disconnect it.

We disconnect and remove the front camera.

We disconnect all the components that are connected to the motherboard.

We extract the three Phillips screws (PH # 000) that hold the motherboard, remove the tray from the cards, and with the help of a flat tool we lift the base plate.

We extract the four Phillips screws (PH # 000), and using a flat tool we will detach and unhook the side buttons.

Remove the four Phillips screws (PH # 000) that hold the shield, and with the help of a flat tool we can remove the battery with shielding and wireless charging.

Finally, using the adhesive strips between the battery and the shield, we will remove the battery that we are going to replace.