To begin we must apply heat to all the edges of the casing, and then take off using a tool fine enough.

We extract the 3 Phillips screws (PH # 00) that hold the two covers that we removed in the photographs.

Disconnect the battery, and under the flex there is a screw that holds the shield that is on the camera, remove the Phillips screw (PH # 00) and we can unhook the shield.

Remove the four phillips screws (PH # 00) that hold the housing, and with the help of a flat tool we will disengage it.

We disconnect and remove the cameras.

We disconnect everything that is connected to the motherboard.

We remove the tray from the cards, remove the Phillips screw (PH # 00) that holds the motherboard, disconnect the flex from the screen and we can remove the motherboard.

We remove the Phillips screw (PH # 00) and unhook the speaker with antenna.

Finally we just have to take off and remove the damaged load connector that we are going to replace.