We start by heating the lid to soften the adhesive and make it easier to peel it off. We heat it to about 65 ° C for about a minute.
Step 2 Take off back cover
With the hot back cover, we slide a flat tool around the contour between it and the frame. Once detached, we will disconnect the fingerprint reader to separate it.
Step 3 Remove intermediate housing
We take out the eight Phillips screws (PH # 00) that hold the upper internal shell, undo it and take off the sides of the NFC antenna.
Step 4 Remove internal casings
Remove the seven screws that hold the loudspeaker module and the intermediate internal casing and disengage them.
Step 5 Disconnect components
We disconnected the antenna cables, the flex of the screen and the battery, the front cameras and the flex of the proximity and flash sensor.
Step 6 Removing the motherboard
We remove the Phillips screw (PH # 00) that holds the motherboard and also remove the SIM / SD tray. Now we lift the base plate by the lower part to disconnect it from the auxiliary plate and disengage it.
Step 7 Remove ignition button
We take off the flex of the ignition button of the chassis and disengage it.
Step 8 Power key
To finish, we remove the button support and press the button from the inside to the outside to remove it.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.