The first step, as always, take out the casing. We will use a plastic tool to avoid scratching the phone.

We will remove the battery by prying it with an opening tool.

We must not forget to remove the SIM and SD cards before proceeding to disassemble.

We remove the cover that covers the flex fingerprint sensor. We will disconnect it so as not to break it when the screen is taken out.

In the next step we will need to heat the glass to soften the glue and thus be able to remove the screen more easily.

Below we will see two ways to perform this step.

We will use a high thermal retention blanket (HOT GLASS) to heat the glass.

Insert the HOT GLASS in the microwave for the time specified in the instructions.

To heat it evenly, it is necessary to interrupt the microwave every 30 seconds to distribute heat throughout the HOT GLASS with your hands.

The gun emits VERY hot air, use with caution.

We recommend the use at minimum power and short bursts, since excess heat can damage the equipment.

Warm the screen to soften the glue and be able to easily peel it off.

Once we heat the screen, we will take off with the pick. If necessary, it will be heated again to continue taking off.

We must not separate the screen at all since it is still connected to the board.

By separating the screen a little, we can see the flex. We will use a tool to disconnect it before we finish separating the screen.

Once we have separated the screen, we have access to a lot of Phillips screws. Remove the screws and take off the flexes of the buttons at the bottom.

We can now separate the chassis from the frame.

While a bug with the face of few friends holding our mobile phone, we take the opportunity to show you where the screws are!

Remove the screws that hold the bottom plate. We disconnect the flex from the motherboard and unplug the antenna cables.

Helping us with a tool, we will leverage to remove the plate.

Now, if we have removed the screw that holds the plate, we can remove it and place it next to the photo. :)

We take off the flex of the housing and we can remove the connector.