Remove the battery cover. Use a plastic tool to avoid damaging or scratching the case.

Make sure the mobile is turned off.

To remove the battery, pull on the bottom.

Remove the 9 Phillips screws that hold the housing.

Separate the intermediate housing. Use a plastic tool to avoid damaging or scratching the case.

Disconnect the data cables and the Phillips screw that hold the motherboard.

Separate the motherboard from the rest of the equipment.

Remove the Phillips screw that holds the component.

Pull gently on the connector to remove the component.

Remove the plastic holder that holds the component.

Remove the component by pulling gently on it.

Peel off the vibrator from the housing by inserting a pointed tool under it and prying it gently. Do not pull on it until it is completely detached as it can break the flex cable.

Remove the Phillips screw to remove the lower module.

Peel off the bottom plate with a plastic tool.

If necessary, apply heat with the Hot Glass.

Disconnect the coaxial cable from the antenna.

To separate the glass window and the display, refer to the display separation manual:

http://yoloreparo.com/demo/manuales/otras-reparaciones-109/separacion-de-displays-613