To begin, we apply heat to the back cover to soften the adhesive that holds it, and with the help of one or more plastic spikes we will take off the back cover.

Manually open the camera rail, remove the six Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will unhook the intermediate housing.

We disconnect all the components that are connected to the motherboard.

We remove the two plastic covers, and remove the ten Phillips screws (PH # 00) that hold the motherboard and the camera module.

We remove the shield of the first photograph, and we extract by sliding the motherboard and the camera module.

We remove the two Phillips screws (PH # 00) that hold the lifting motor that we are going to replace, and with the help of a flat tool we will remove it.