To begin, we apply a little heat with a thermal mat to the back cover to soften the adhesive that holds it, and with the help of a thin tool, we will open a small hole through which we will introduce a plastic spike and take off all the edges of the housing. We use a plastic tool as this is less likely to damage the back cover.

Remove the fourteen Phillips screws (PH # 00) that hold the intermediate housing, remove the card tray, and with the help of a plastic spike we will unhook all the edges of the housing.

We disconnect the battery to work with greater security.

We disconnect the flex bridge, remove the front camera, also disconnect the coaxual cable, remove the Phillips screw (PH # 00) that holds the motherboard with the rear cameras, and using a flat tool we will lift it.

Finally, with the help of flat tweezers we will take off the vibrator that we have to change.