Before you start, make sure your mobile is turned off.

Remove the back cover. Using a plastic opening tool will prevent scratches.

Remove the battery by pulling on the bottom.

Remove the SIM and SD cards.

Remove the 11 Phillips screws that hold the middle housing.

Disassemble the intermediate housing with the opening tool.

The volume and ignition keys are not attached, so that when separating the intermediate casing, they will simply come off.

Remove the adhesive covering the connectors on the motherboard.

Remove the microphone and the vibrator from the intermediate housing.

Take off the touch screen data flex.

Press the connector tab and unplug the flex from the motherboard.

Unplug the display data flex on the motherboard, by pulling the connector tab and pulling gently.

Take off the flex pushbuttons of volume and ignition.

Remove the base plate, fastened by 2 Phillips screws.

Remove the rubber band where the proximity sensor would be located. This rubber prevents the data flex from passing to the other side.

The screen is attached to the chassis by a strip of adhesive that runs all the way around. To detach it we will apply heat to soften the adhesive and to peel off easily.

Use our Hot Glass, our high thermal retention blanket. Simply insert your Hot Glass in the microwave (see instructions), and when you reach the desired temperature, apply directly to the screen.

Insert the prong between the glass and the plastic frame.

Scroll the contour to detach the adhesive, avoiding damaging the data flex.

Finally, separate the screen from the chassis.