First, we will apply heat to all the edges of the back cover to soften the adhesive that holds it.

With the help of a fine tool, we will open a small hole through which we will insert a plastic tool, with which we will be less likely to damage the casing.

We remove the eleven Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will lift it.

We disconnect the battery to work with greater safety.

We remove the Phillips screw (PH # 00) and the Standoff that prevents us from removing

the plate, and once removed we can lift it.

We unhook the shields and disconnect the cameras and we can remove them from the motherboard.

And to finish we will take off the rear camera that was not in the previous module.