To begin we must remove the back cover, for this we must apply heat, and introduce a sufficiently fine tool and then introduce one or more plastic tines to avoid damaging the case.

We extract the eleven Phillips screws (PH # 00) that hold the intermediate housing, and using a flat tool we will unhook it.

We disconnected the battery for safety.

We disconnected the three connectors of the rear cameras, and removed the module.

We disconnect and remove the front camera.

We disconnect the components of the motherboard.

Remove the Phillips screw (PH # 00) that holds the motherboard, and with the help of a tool we will remove it and we can put the new one in its place.