To begin we must remove the back cover, for this we must apply heat, and introduce a sufficiently fine tool and then introduce one or more plastic tines to avoid damaging the case.

We extract the eleven Phillips screws (PH # 00) that hold the intermediate housing, and using a flat tool we will unhook it.

We disconnected the battery for safety.

We disconnected the three connectors of the rear cameras, and removed the module.

We disconnect and remove the front camera.

Disconnect all components that are connected to the motherboard, remove the Phillips screw (PH # 00) that holds the motherboard and we can remove it.

With the help of a pair of tweezers, we will remove the key and take off the flex with the push button.

We take off the vibrator by introducing tweezers underneath.

With the help of a pair of tweezers, we will remove the hollow cover where the push buttons are located, tilting the telephone and the keys will come off, and with the help of the tweezers we will take off and remove the flex from the push buttons.

We take off and remove the receiver.

Take off and remove the battery, and the stickers that are underneath and on the sides of the battery.

We extract the eight Phillips screws (PH # 00) that hold the loudspeaker, and with the help of a flat-tip tool we will unhook it.

We disconnect all the components that are connected in the auxiliary plate.

With an extraction tool we will remove the tray from the cards.

Remove the two Phillips screws (PH # 00) that hold the auxiliary plate, with the help of a flat tool we will turn to disconnect the coaxial cable that is connected to the back of the auxiliary plate.

Remove the two coaxial cables.

Take off the flex with charging connector.

We take off the bridge flex.

Remove the two Phillips screws (PH # 00) that hold the fingerprint reader, and we can extract it.

To finish we only have to take off the flex with the card reader.