First we have removed the tray for the cards.

We apply heat to the back shell to soften the adhesive that holds it, with the help of a thin tool we will open hollow to introduce one or more plastic tines, and thus detach the back cover without damaging it.

Remove the eleven Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will unhook it.

We will disconnect the battery to avoid possible damage.

We remove the eleven Phillips screws (PH # 00) that hold the loudspeaker module, and with the help of a tool we will detach it.

Disconnect the components that are connected to the motherboard, and remove the rear cameras.

We disconnect the flex from the upper module, the coaxial cables, and we can unhook the motherboard.

Unhook the plastic cover that holds the keys inside the chassis, and when you remove it the key itself will be released, and with the help of a flat clamp we will take off the flexes with the side pushbuttons on both sides.

We extract the five Phillips screws (PH # 00) that hold the elevator motor and we will take off with a pair of flat tongs.

We removed the upper module, and being careful with the flex.

We disconnect and remove all the flexes that are above the battery.

We disconnect the flex from the screen, lift the auxiliary plate, and disconnect the coaxial cable.

Take off the vibrator and the fingerprint reader with flat tweezers.

Take off the battery and remove the stickers.

Finally we have removed the two coaxial cables from the screen that we are going to replace.