We start by applying heat to the back of the terminal and with the help of a fine tool we take off the battery cover around its entire contour until it is detached from its housing

Next, we peel off the adhesive that is on the camera lens and extract the eight Phillips type screws (PH # 00) and remove the camera lens from its housing.

Next we disconnect the fingerprint reader connector and with the help of a Phillips-type screwdriver (PH # 00) we extract the five screws from the bottom of the terminal, then we remove the sim tray and with the help of a fine tool we extract the intermediate housing by all its contour

The next step will be to disconnect the battery with the help of a fine plastic tool to avoid incidents

In this step we will extract the upper protection casing by removing the only Phillips-type screw (PH # 00) that holds it in its housing.

Then we release all the connections that rest on the motherboard once released, we will remove the motherboard from its housing

In this step we will remove all the components of the motherboard to free it