First of all we must apply heat to the back shell to soften the adhesive that holds it, and with the help of a fine tool we will open a small hole through which we will introduce a plastic tool, with which it will be less likely to damage the shell.
Step 2 Upper housing
We remove the fourteen Phillips screws (PH # 00) that hold the intermediate casing, and with the help of a flat tool we will unhook it.
Step 3 We disconnect battery
We disconnect the battery to work with greater security.
Step 4 Speaker
We remove the eight Phillips screws (PH # 00) that hold the speaker module, and with the help of a flat tool we will remove it.
Step 5 Components
We disconnect all the components that are connected on the auxiliary board, without forgetting the card tray.
Step 6 Auxiliary board
We remove the Phillips screw (PH # 00) that holds the auxiliary plate and using a flat tool we will remove it.
Step 7 Battery
We detach the battery and the adhesive that surrounds it.
Step 8 Charging connector
We disconnect the flex from the charging connector of the motherboard, we take it off, we extract the two Phillips screws (PH # 00) that hold the connector, and we can remove it.
Step 9 Fingerprint reader and vibrator
We take off the fingerprint reader and the vibrator.
Step 10 Screws
We remove the two Phillips screws (PH # 00) that hold the motherboard.
Step 11 Bridge Flex
We disconnect the flex bridges from the motherboard, and we will take them off with a flat tool.
Step 12 Coaxial cables
We disconnect all the coaxial cables, and we will remove the ones that we can remove.
Step 13 Motherboard with rear cameras
We disconnect the front camera, and we can now lift the motherboard.
Step 14 Lifting motor
We remove the two Phillips screws (PH # 00) and the Standoff that we indicated in the first photo, and with the help of a flat tool we will take off the elevator motor.
Step 15 Frontal camera
We remove the two Phillips screws (PH # 00) that hold the front camera, remove the shield and we can now remove the front camera.
Step 16 Handset
We extract the Phillips screw (PH # 00) that holds the earpiece, and with the help of a metallic tool we will detach the earpiece.
Step 17 Coaxial cables
We remove the two Phillips screws (PH # 00) that hold the cover, and once removed we can disconnect the coaxial cables.
Step 18 Fullscreen
Finally, we will only have to remove the Phillips screws (PH # 00), which hold the plates with antenna contacts that are by the edges of the screen frame that we are going to replace.
Video Tutorial summary
In this video you can watch a quick summary of the tutorial, but we recommend to follow the complete tutorial, with its explanations and detailed images.