To begin we apply heat to the back shell and with the help of a fine tool we will make a hole to introduce one or more plastic tines.

We remove the 14 Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will unhook it, we must be careful with the flex of the flash module.

With a flat tool we will disconnect the battery to avoid possible damage.

Remove the eight Phillips screws (PH # 00) that hold the module, and with the help of a flat tool unhook the speaker.

We remove the tray from the card, and disconnect all the components that are connected in the auxiliary plate that we have to change.

We extract the Phillips screw (PH # 00) that holds the auxiliary plate, and with the help of a flat tool we will detach it.

Finally we will only have to take off the damaged vibrator that we have to replace.