To begin we apply heat to the back shell and with the help of a fine tool we will make a hole to introduce one or more plastic tines.

We remove the 14 Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will unhook it, we must be careful with the flex of the flash module.

With a flat tool we will disconnect the battery to avoid possible damage.

We disconnect the components that are connected to the motherboard.

With the help of a pair of tweezers, we will disconnect all the coaxial cables that are connected to the motherboard.

We remove the two Phillips screws (PH # 00) that hold the motherboard, but before removing the motherboard, we must lift the shield that is above the connector of the front camera and disconnect it.