To begin we apply heat to the back shell and with the help of a fine tool we will make a hole to introduce one or more plastic tines.

We remove the 14 Phillips screws (PH # 00) that hold the intermediate housing, and with the help of a flat tool we will unhook it, we must be careful with the flex of the flash module.

With a flat tool we will disconnect the battery to avoid possible damage.

We disconnect the components that are connected to the motherboard.

With the help of a pair of tweezers, we will disconnect all the coaxial cables that are connected to the motherboard.

We remove the two Phillips screws (PH # 00) that hold the motherboard, but before removing the motherboard, we must lift the shield that is above the connector of the front camera and disconnect it.

We remove the module with the three rear cameras so that it does not bother us.

We remove the Phillips screw (PH # 00) that holds the headset, and with the help of a tool with the curved tip we will detach it.