To start we will remove the back cover.

We remove the battery.

We remove the four Phillips screws (PH # 00) and the 3 Torx (T4) that hold the speaker module, and with the help of a flat tool we will unhook it.

We remove the five Torx screws (T4) and the two Phillips (PH # 00) that hold the intermediate housing, remove the stickers that are on the edges and we can unhook the housing.

When you remove the adhesives check that they are adhesives and not the antennas.

We remove the adhesive that covers the front camera, and disconnect it.

We disconnect and remove the proximity sensor and the fingerprint reader.

We disconnect and remove the rear cameras.

We disconnect the flex from the side push buttons and the flex from the screen.

We remove the stickers that cover the two Phillips screws (PH # 00) that hold the motherboard, remove them and we can lift the motherboard carefully, and disconnect the coaxial cable that is connected at the back of the board.

We take off the headset and the side buttons.

We remove the coaxial cable and take off the headset and the auxiliary plate from the screen that we have to replace.