We will start by separating the chassis screen. First we remove the two pentalobe screws that we will find in the lower part of the chassis. Then, with a flat opening tool, we will make a lever to separate it moving around the contour.

We will be careful when separating the screen since it is still connected.

Remove the Phillips screws (PH # 00) that hold the shields of the screen connector and the fingerprint sensor in order to disconnect both and separate the screen from the chassis.

We remove the armor that covers the connector of the rear cameras and the flex of lateral push buttons to be able to disconnect the latter. Then we disconnected the battery and the flex from the back screen.

Now we will remove the fourteen Phillips screws (PH # 00) that hold the shields and supports of the plate and remove them.

That you do not pass the screw in the upper left part of the base plate that is hidden behind an adhesive. We will also remove the SIM / SD tray in order to disengage the motherboard.

All that remains is to take off the chassis vibrator.