First, we apply heat to the back cover to soften the adhesive that holds it, we introduce a plastic spike-type tool so as not to damage the case, and we separate it all around.

Next we extract the SIM / SD tray from its housing.

With a Phillips screwdriver (PH # 00) we remove the ten indicated screws to separate the housing from the terminal with a thin plastic tool.

With a fine opening tool we disconnect the battery to work more safely.

Then we will extract the battery, gradually lifting the adhesive that surrounds it.

With a Phillips screwdriver (PH # 00), we remove the eight screws from the speaker and vibrator module, and with a thin plastic tool we remove it from its housing.

By mistake the battery is lodged in its place, despite having removed it in the previous step.

With a flat plastic tool, we loosen the coaxial connection at its end to be able to extract the auxiliary plate.

We release the connection of the interconnection flex of the auxiliary plate with the help of a thin plastic tool, and with it we lift the plate from its housing until it is extracted.

Returning to the motherboard, we extract the holding shield of the rear cameras.

We release all the connections that are on the motherboard to be able to remove it.

We extract both Phillips screws (PH # 00) that hold the plate to the terminal chassis, with a thin plastic tool we lift it from one end to remove it from its housing.

With a thin metal tool we detach the flex from the terminal chassis, and extract the securing shield from it.

We take off the flex of the fingerprint reader that is attached to the chassis, once detached, we extract the two Phillips screws (PH # 00) and the shield that hold it to be able to remove the fingerprint reader from its housing.

With a fine tool we detach the flex from the side buttons and remove them from their housing.

With a fine tool we remove the flex bridge from the terminal chassis.

With a fine tool we extract the receiver from its housing.

Finally, with a fine tool we detach the proximity sensor from the terminal chassis and remove it.