To begin, we apply heat to the back of the terminal and with a thin plastic tool we begin to take off the battery cover until it is separated.

With a Phillips-type screwdriver (PH # 00) we extract the twelve screws that hold the intermediate housing and separate it from the terminal

With a fine plastic tool we disconnect the battery to avoid unforeseen events.

We remove the six screws of the holding cover for the removal of components.

Then we release all the connections that we find on the auxiliary plate as well as the interconnection flexes that we will release at both ends on both the auxiliary plate and the motherboard

We extract the sim tray from its housing and then we can remove the auxiliary plate from its housing.

With the help of antistatic tweezers, we remove the charging connector from its housing.

Now we can remove the speaker from its place without any problem.

Now we can remove the coaxial cables located on the motherboard as well as the Phillips-type clamping screw (PH # 00) that holds the motherboard in place.

We remove the rest of the connections that are on the motherboard and once they are loose, we can lift it from its lower corner and remove it with the help of a fine tool.

Now with the help of a fine tool we can remove the side pushbuttons, detaching them little by little from their housing.