To begin with we will have to take off the back cover, for this we will use a fine enough prong to take off the casing. If necessary, before introducing the tool we could apply heat to the housing with a hot air gun or a thermal mat.

We took off the adhesive and removed the seven Phillips screws (PH # 00) that hold the shield in order to remove it.

We disconnect the coaxial cables and the interconnection flex from the auxiliary plate.

We extract the two Phillips screws (PH # 00) that hold the auxiliary plate, and we can remove it.

We take off the vibrator with the help of tweezers.

We take off the speaker.

Remove the eight screws that hold the upper casing and unhook it.

We disconnect and remove the load connector flex.

We take off and remove the receiver.

We disconnect and remove the front camera.

We disconnect and remove the flex with lateral push buttons with the help of tweezers.

We unhook the side keys with the help of fine tweezers.

We disconnect all the flexes that prevent us from removing the motherboard, remove the tray from the cards and remove the motherboard.

Finally, we would only have to remove the battery.