First of all we must apply heat to the casing to soften the adhesive that holds it, and with the help of a fine metal tool we will open a small hole through which we will introduce one or more plastic spikes, and thus it will be less likely to damage the casing.

We peel off the adhesive that is above the connector and we can now disconnect the fingerprint reader.

We remove the eleven Phillips screws (PH # 00) that hold the intermediate casing, and with the help of a flat tool we will unhook it.

We disconnect the battery to work with greater security.

We disconnect and remove the flex bridge that connects the fingerprint reader and the motherboard.

We extract the tray.

We disconnect and remove the rear cameras, and we will disconnect the rest of the components that are connected to the motherboard.

We remove the Phillips screw (PH # 00) that holds the shield that covers the connector of the front camera, we unhook the shield and disconnect the front camera, and now we can remove the motherboard.

We remove the four Phillips screws (PH # 00) that hold the motor, and with the help of tweezers we will detach the area of the contacts.

We remove the Phillips screw (PH # 00) and the shield that acts as a stop for the camera, and we can now remove the front camera.

Using the adhesive strips, we will detach the battery taking care not to damage it.

We extract the seven Phillips screws (PH # 00) that we indicated in the first photograph, and with the help of a flat-tipped tool we will unhook both the cover and the speaker.

We disconnect the bridge flex and the coaxial cable, we have already taken advantage of unhooking the coaxial, and with the help of a flat tool we will unhook the auxiliary plate.

With the help of a flat tool we will take off the vibrator.

We take off the bridge flex.

We will unhook the cover that covers the hollow of the buttons, and with the help of a metal pick we take off the buttons.

To finish, if the new screen that we have does not have side buttons, we must remove the buttons from the old screen, for this we must push them from inside the chassis with the help of a fine enough tool.