To begin with we must apply a little heat to the edges of the back cover to soften the adhesive that holds the casing, and with the help of a suction cup and a pick we are taking off all the edges.

Remove the eight Phillips screws (PH # 00) that hold the housing and remove the adhesive that is above the battery.

We disconnect the flexes that are connected to the motherboard.

We disconnect and remove the front camera.

We disconnect and take off the audio connector.

Disconnect the coaxial cable, remove the card tray and we can lift the motherboard. We must lift the motherboard from the lower right corner, as we do in the fourth photograph, since in that corner there is a metal tab that is the one that holds the chassis of the phone.

Finally, we disconnect the cameras that we are going to replace from the motherboard.