Remove the equipment from the outer casing with the opening tool from the front.

Remove the battery by pulling on the bottom.

Push the SIM card with your finger to eject it.

Pull the micro SD card to eject it.

Remove the 8 Torx screws. One of them is hidden under a sticker with the text: "VOID".

Remove the black cover stuck to the top of the battery gap.

Release the plastic hooks using the opening tool.

Shut off the casing.

Disconnect the coaxial cable from both ends.

Pull it to remove it from the housing.

Remove the load connector bracket. This is fastened by two Torx screws.

Peel off the lower plate, it will continue to be held by the flex cable connector.

Separate the lower plate by disconnecting the flex cable.

Peel off the sticker with the serial number and IMEI of the equipment.

Peel off the second adhesive covering the interconnecting cable between the plates.

Remove the adhesive covering the lower connector.

Press the connector clip and pull the flex cable to disconnect it.

Separate the base plate from the housing a few centimeters on the right side.

Disconnect the vibrator cable from the motherboard.

Separate the plate on the right side. This will continue to be held on the opposite side by the screen's data flex.

Operate the connector clip and pull the plate gently to snap it off.

Remove the handset by removing it with fine-nose pliers.

Remove the vibrator by pulling it.

Insert the HOT GLASS in the microwave for the time specified in the instructions for use.

If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.

The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.

Apply heat to the screen for a few minutes.

Insert a prong into the joint between the digitizer and the housing.

Move it around the contour to release the glue.

You should not force it because you could break it.

Repeat the previous step and apply heat as many times as necessary until it comes off easily.

Help yourself with a plastic tool to detach the display.

Make sure that the flex cables do not bend or jam as they may break.

If you need to change only the glass window (in case of breakage, for example), see the display separation guide:

http://yoloreparo.com/demo/manuales/otras-reparaciones-109/separacion-de-displays-613