First we will heat the back of the phone to soften the adhesive that holds the back cover, and to take it off we will use a fine tool to go off all edges.

Remove the two Pentalobe screws (TS1) from the bottom of the phone, before starting to unhook the frame we will remove the tray from the cards, and then with the help of a plastic pick we will unhook all the edges of the frame.

We extract the seven Phillips screws (PH # 00) that hold the shield with the fingerprint reader and the antenna module.

We disconnect all the components that are connected to the motherboard.

We extract the Phillips screw (PH # 00) that holds the base plate in the lower left, and we can lift the base plate.

To finish we can disconnect the damaged front camera that we are going to replace.