First we will heat the back of the phone to soften the adhesive that holds the back cover, and to take it off we will use a fine tool to go off all edges.

Remove the two Pentalobe screws (TS1) from the bottom of the phone, before starting to unhook the frame we will remove the tray from the cards, and then with the help of a plastic pick we will unhook all the edges of the frame.

We extract the seven Phillips screws (PH # 00) that hold the antenna module with loudspeaker, and with an opening tool we will unhook it.

We extract the three Phillips screws (PH # 00) that hold the shield, and with the help of a pair of tweezers and a flat tool we will take off the shielding of the base plate, and disconnect the connector from the fingerprint reader.

We disconnected the flex from the battery, and both ends of the interconnection flex.

Pulling the adhesive tape that protrudes through the bottom right of the battery, we will remove the entire right part of the battery, to take off what remains we will introduce a plastic tool and remove the battery carefully.