To begin with, we apply heat to the back shell, and with the help of one or more plastic spikes we will detach all the edges of the shell, and we will have to detach the rear flash from the shell.

We remove the three Torx screws (T4) that hold the shield and remove it, and we will disconnect the battery to work with greater security.

We extract the two Torx screws (T4) that hold the shield that covers the connector of the rear flash, and we will disconnect it.

We extract the 6 Torx screws (T4) that we point out in the photographs, and remove the shields that they hold.

We disconnect the flex from the front camera module, extract the two Torx screws (T4) that hold the module, and with the help of a flat tool we will remove the module.

We take off and remove the battery.

We remove the four Torx screws (T4) that hold the shield that covers the connectors.

We disconnect all the components that are connected on the motherboard.

We disconnect the two coaxial cables from the motherboard.

We extract the card tray, remove the Torx screw (T4) that holds the motherboard, and with the help of a flat tool we will lift the motherboard.

Finally we can already replace the rear cameras that we have to change.