Before starting, make sure the equipment is turned off.

Remove the back cover with the opening tool, this will avoid scratching the case.

Remove the battery by pulling on the bottom.

Take out the micro SD card by pulling it.

Remove the SIM card (s) by pushing out with your finger.

Remove the 8 Phillips screws to open the housing.

One of the screws is hidden behind a white sticker, as shown in the image.

Use the prong to release the plastic hooks that hold the housing around the mobile.

Separate the intermediate housing.

Disconnect the flex cable from the digitizer. To do this, pull the connector tab and pull it gently.

Take off the flexes of the side buttons.

Disconnect the data cable from the display and detach the plate a little to gain access to the camera.

Unplug the camera by pulling gently on the connector.

Peel off the bottom flex to separate the base plate.

To remove the speaker, remove it from the housing.

Insert the HOT GLASS in the microwave for the time specified in the instructions for use.

If you heat it too long, the gel inside will expand and the bag will be inflated until the content is poured.

The last minute in the microwave is advised to interrupt every 15 seconds and knead the gel inside with your hands to distribute the heat.

Apply heat for a couple of minutes.

Insert the tip of the tine into the joint between the screen and the housing frame.

Scroll around the contour of the phone to peel off the glue.

Avoid the upper area where the flex data cable passes since you could cut it with the barb.

Separate the screen from the bottom and make sure that the flex cable does not bend or jam, it could be damaged.

If you need to change only the glass window (in case of breakage, for example), consult the display separation guide:

http://yoloreparo.com/demo/manuales/otras-reparaciones-109/separacion-de-displays-613