We will start by taking the screen. To do this, first remove the two Pentalobe 0.8 screws (TS1) that hold the screen to the housing.

Then, using a suction cup, we will make room to introduce a flat tool and remove the strip of adhesive that holds it.

Now we will have to remove the shielding from the connectors on the motherboard. For this we will remove the five Triwing screws (Y0.6) that hold it.

Once the shield has been removed, we will disconnect the flexes from the screen and the headset.

Remove the five Triwing screws (Y0.6) that hold the shield and remove it.

Now we will remove the screws that hold the speaker. A Phillips (PH # 00), a standoff and a triwing (Y0.6) that holds the shield of the speaker connector, which we will disconnect.

To finish, we remove the last standoff screw that holds the speaker and take off the adhesive strip that holds it to the vibrator.